Chapter A7: Set Preferences
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A7-15
Operator Manual © 2008 General Electric Company. All rights reserved.
Auto Refresh
The Worklist Auto-Refresh feature automatically refreshes the Patient Worklist at predefined time
intervals.
NOTE: You will not be able to make selections or access Worklist functions while the Worklist is refreshing.
NOTE: For large facilities, it is recommended that the auto refresh interval be set to a short time, for
example, every 1 or 2 minutes. The system will refresh more often, but each refresh will take less
time to complete.
Preset Names
The Preset Names screen (Figure A7-12) allows you to add, remove, or edit the names that appear on the
Add Patient/Patient Information screen’s Operators, Performing Physicians, and Referring Physicians
drop-down lists (Figure A7-11).
Figure A7-11 Drop-down lists on the Add Patient screen
1. Follow the procedures below to Add, Edit, or Remove Preset Names.
2. When finished, press [SAVE] to retain the changes you made.
Auto Refresh
[ON] [OFF]
Turns Auto Refresh on or off.
Refresh every __
Minutes
If Auto Refresh is [ON], sets how often (in minutes) the Worklist refreshes.
The interval may be between 1 and 9999 minutes.
Function Description
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
