Chapter A7: Set Preferences
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A7-13
Operator Manual © 2008 General Electric Company. All rights reserved.
Worklist
Worklist preferences are available from the Utilities screen.
1. On the Worklist screen, press [UTILITIES].
2. Select Preferences > Worklist.
Figure A7-9 Preferences – Worklist screen
Default Query
The Worklist Default Query controls the amount of HIS/RIS information that appears on the Worklist and
allows you to enable and configure the auto-refresh function.
1. Complete or edit the Worklist Default Query screen (Figure A7-10). Table A7-6 describes the fields in
detail.
2. Press [SAVE] to change the Default Query.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
