EasyManua.ls Logo

GE Definium AMX 700 - IEC 60601-1 Classifications; Applicable Symbols

GE Definium AMX 700
240 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 2: Safety and Regulatory
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) 2-6
Operator Manual © 2008 General Electric Company. All rights reserved.
Under most conditions, cumulative radiation dose to the operator will not exceed recommended
maximum permissible levels. However, as with all radiation-producing devices, a qualified radiation
expert should evaluate situations involving frequent exposures using high kVp and mAs technics to
determine if extra protective devices are necessary.
IEC 60601-1 Classifications
Type of protection against electric shock: Class I, Internally Powered
Degree of protection against electric shock: Type B Applied Part
Degree of protection against ingress of water: Ordinary
Mode of operation: Continuous
Applicable Symbols
Table 2-1 Symbols
Symbol Definition
This symbol on the equipment means that the accompanying operating instructions
should be consulted to assure safe operation.
Store and operate the detector within the range of 0° to 50°C (32°-122°F) to avoid
damage.
To avoid damage do not place a load in excess of 160kg (350lb) on the detector.
In accordance with UL 60601-1, the Definium AMX 700, is classified as Type B
Equipment, Class I Equipment, Internally Powered Equipment, Ordinary Equipment
and continuous operation. Type B Equipment provides an adequate degree of
protection against electric shock, in particular regarding:
allowable leakage current,
reliability of the protective earth connection
Dangerous voltage. Indicates an avoidable dangerous high voltage hazard.
Alternating Current. Indicates equipment that is suitable for alternating current only.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).

Table of Contents

Related product manuals