Chapter A5: Image Viewer
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A5-13
Operator Manual © 2008 General Electric Company. All rights reserved.
Add Image Annotations
NOTE: All image annotations initially appear in the same place (center of image) and are the same shape,
size, and/or angle. It is possible to have multiple annotations of the same kind stacked on top of
each other.
Follow this process to add image annotations.
1. Select the image to annotate, if necessary.
2. Press the button of the annotation to insert.
NOTE: Selected image annotations are yellow with red handles. Unselected image annotations are aqua
without handles.
3. Move, re-size, or change the angle of the annotation as described in Table A5-5.
NOTE: When resizing annotations, make sure that the pointer arrow is inside the square handle and has
changed to a “+” sign (Figure A5-8) before trying to move the handle.
Figure A5-8 Active annotation handle
Table A5-5 Image annotation instructions
Tool Instructions
Line Select the line.
• To move: Press and drag the middle of the line.
• To change the angle: Press and drag one of the square handles
at the ends of the line.
• To resize: Press and drag one of the square handles at the ends
of the line.
Ellipse Select the ellipse.
• To move: Press and drag the ellipse by its edge (not on a handle).
• To change shape or re-size: Press and drag a square handle.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
