Chapter 3: Hardware Overview
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) 3-6
Operator Manual © 2008 General Electric Company. All rights reserved.
Figure 3-2 Control and display panel
Table 3-2 Control and display panel functions.
Hand Switch
Exposures are made with the console hand switch. The Prep/Expose button on this switch has three
positions: OFF, PREP, and EXPOSE.
Some units may have a wireless TechSwitch to be used instead of the hand switch shown in Figure 3-3.
Refer to TechSwitch
(p. 3-7) for information.
Item Description
1 kVp and mAs technique display when in acquisition mode.
2 Exposure indicator light. Lights up when exposures are taken.
3 Battery capacity indicator.
4 Battery charging status, system status, or error message display.
5 kVp and mAs technique controls (acquisition mode).
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
