Chapter A4: Image Acquisition
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A4-8
Operator Manual © 2008 General Electric Company. All rights reserved.
Figure A4-3 Select Protocols
Use this process to select or change protocols for a procedure.
1. If multiple procedures were selected from the Worklist, select the procedure from the drop-down list.
Figure A4-4 Select procedure
2. Press on an anatomical category (Available Protocols side) to open it.
The category expands to show the available exams.
Press on the anatomical category name again to close it.
3. Press on an exam to select it.
A checkmark appears in the box to the left of the exam name.
A checkmark appears next to the category name. This indicates that the category has at least one
exam selected.
Figure A4-5 Selected exams
The category and exam name appear in the Selected Protocols list.
4. Press the exam again to de-select it.
The category and exam name are removed from the Selected Protocols list.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
