Chapter A7: Set Preferences
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A7-24
Operator Manual © 2008 General Electric Company. All rights reserved.
Table A7-9 Auto Delete functions
Function Description
Auto Delete
[ON] [OFF]
Turns Auto Delete on or off.
Auto Delete images when
database is __% full.
Specifies when to auto delete images based on database size.
Delete images until
database is __% full.
Specifies how many images to delete based on database size.
Images must be at least
__ Days old before
deletion.
Specifies how old (in days) an image must be for it to be deleted. Images
that are less than the entered number will not be deleted.
Images must meet __ of
the checked options
before deletion.
Allows you to constrain the deletion of raw and processed images
based upon checkbox selection (see below).
Available options are:
•All
•Any
•None
Processed image printed Selecting the Print parameter allows auto deletion of images that have
been printed.
Processed image sent Allows auto deletion of processed images with no errors that have been
sent to another viewing station.
Processed image
committed
Allows auto deletion of processed images that have been sent to a long
term device with storage commitment capability.
Storage commitment for a network host is configured from the System
– System screen, Network Connections.
Allow Non-Quality
Checked (tagged) images
to be deleted regardless
of being sent, committed
or printed.
Allows auto deletion of any images that do not have the Auto Tag
(Quality Check) mark.
NOTE: If any of the images in the series have the Auto Tag (Quality Check)
mark, the series will not auto delete.
[SAVE] Saves your changes and closes the screen.
[CANCEL] Closes the screen without saving changes.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
