Chapter A7: Set Preferences
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A7-45
Operator Manual © 2008 General Electric Company. All rights reserved.
5. From the Position View After drop-down list, select the placement of the view within the exam.
6. Select the Acquisition Type.
Available options are:
– Standard
–Bone
–Soft Tissue
7. Check if horizontal flip is to be applied when displaying the image.
8. Select the Anatomy.
NOTE: The selected anatomy will determine the image processing for the view. Be sure to select the
appropriate anatomy for the body part imaged.
9. Select the most appropriate View (AP, Lat, etc.).
The selected anatomy determines which views are available.
10. Select the Laterality:
The selected anatomy determines which laterality options are available.
– If the anatomy is unpaired, then Unpaired is the only available selection.
– If the anatomy is paired, the available sections are: Both, Left, and Right.
– Paired anatomy enables the Patient Side control on the Image Acquisition screen. Refer to
Chapter A4: Image Acquisition
for more information.
11. Select the Default Position:
The selected anatomy determines which positions are available. In general:
– If the anatomy is unpaired, the selections are Head Down or Head Up
– If the anatomy is paired, the selections are Digits to Back, Digits to Feet, Digits to Front, Digits to
Head.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
