Chapter 4: Moving and Positioning
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) 4-2
Operator Manual © 2008 General Electric Company. All rights reserved.
If moving down hallways or just traveling from one room to another, first make sure that the telescoping
arm is properly positioned and securely latched and that the detector is also in the detector bin so that
maximum speed can be reached.
Then, simply grip the drive handle (Figure 4-2) and steer the unit to your destination.
Figure 4-2 Drive handle
WARNING: Movement of the Definium AMX 700 x-ray unit could cause the horizontal arm to slide and
strike an operator or patient if not latched properly. Latch telescoping arm properly before
moving the unit.
WARNING: Do not drive or position the Definium AMX 700 unless standing directly behind it (Figure 4-
3). Failure to do this may result in loss of control causing serious injury and equipment
damage.
Figure 4-3 Proper driving position
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
