Chapter 7: Maintenance and Service
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) 7-3
Operator Manual © 2008 General Electric Company. All rights reserved.
Check that Detector Power
Supply cables and cable
retention clips are securely
in place
Every year (Refer to Service Documentation CD-ROM 5161519-200.)
Exposure tone is audible and
x-ray on indicators light up
when hand switch
depressed to expose
position
Every year (Refer to Service Documentation CD-ROM 5161519-200.)
Auxiliary items (battery
charger, HV cables, etc.)
Every year (Refer to GE Portable DR Detector PM Schedule.)
Detector calibration Every year (Refer to GE Portable DR Detector PM Schedule.)
Visual inspection of detector,
tether and grid for damage,
wear, etc.
Every year (Refer to GE Portable DR Detector PM Schedule.)
Inspect PC shock mounts for
damage/wear
Every year (Refer to GE Portable DR Detector PM Schedule.)
Verify the PC is still mounted
securely.
Every year (Refer to GE Portable DR Detector PM Schedule.)
Inspect monitor for damage/
wear
Every year (Refer to GE Portable DR Detector PM Schedule.)
Check that the monitor is
tightly bolted to the top
cover.
Every year (Refer to GE Portable DR Detector PM Schedule.)
Monitor calibration Every year (Refer to GE Portable DR Detector PM Schedule.)
Touch screen calibration Every year (Refer to GE Portable DR Detector PM Schedule.)
Equipment and Serial
Number:
Date of Inspection:
Maintenance Check
Performed By:
Maintenance/Checks Frequency
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
