GE Giraffe OmniBed Carestation CS1 - Page 14

LOF-2 Service Manual
FIGURE 7-12. Hole Fill Assembly (2x) for Canopies with Six Holes across North End..........7-9
FIGURE 7-13. South Seal Parts................................................................................................................... 7-10
FIGURE 7-14. South Corner Parts ............................................................................................................. 7-11
FIGURE 7-15. North Corner Parts.............................................................................................................. 7-11
FIGURE 7-16. Installing Rail Spacers ....................................................................................................... 7-12
FIGURE 7-17. Soffit .......................................................................................................................................... 7-14
FIGURE 7-18. Trimming the Soffit............................................................................................................. 7-14
FIGURE 7-19. Untrimmed and Trimmed Soffit ................................................................................... 7-15
FIGURE 7-20. Rear Cover .............................................................................................................................. 7-17
FIGURE 7-21. Display Head Assembly.................................................................................................... 7-18
FIGURE 7-22. Disconnecting Heater Door Cable............................................................................... 7-19
FIGURE 7-23. Rail Decorative Strips, End Caps, and Wire Cover................................................ 7-20
FIGURE 7-24. Removing the Lift Motor................................................................................................... 7-21
FIGURE 7-25. Right Rail Disassembly...................................................................................................... 7-23
FIGURE 7-26. Rollers and Tensioning Spring....................................................................................... 7-24
FIGURE 7-27. Replacing the Rail Buoyancy Springs......................................................................... 7-25
FIGURE 7-28. Left Inner Rail......................................................................................................................... 7-27
FIGURE 7-29. Left Rail Springs and Spools........................................................................................... 7-28
FIGURE 7-30. Re-attaching the Upright................................................................................................. 7-29
FIGURE 7-31. 3-pin MAT-N-LOK Connector and Bushing.............................................................. 7-31
FIGURE 7-32. Cable Tie.................................................................................................................................. 7-32
FIGURE 7-33. Connector Drawing ............................................................................................................ 7-32
FIGURE 7-34. Opened Cable Guard Latches ....................................................................................... 7-33
FIGURE 7-35. Correct and Incorrect Cable Tie Usage..................................................................... 7-33
FIGURE 7-36. Lift Rail and Cable Carrier Channel Together......................................................... 7-34
FIGURE 7-37. Canopy Alignment .............................................................................................................. 7-35
FIGURE 7-38. Radiant Heater Disassembly .........................................................................................7-37
FIGURE 7-39. Heater Door Cable Adjustment..................................................................................... 7
-39
FIGURE 7-40. Securing String to the Spring Tube ............................................................................. 7-40
FIGURE 7-41. Removal of the Lower M5 Nut....................................................................................... 7-41
FIGURE 7-42. Dog Point of the Set Screw ............................................................................................. 7-42
FIGURE 7-43. Compartment Sensor Disassembly............................................................................ 7-43
FIGURE 7-44. Top Rail End Cap.................................................................................................................. 7-44
FIGURE 7-45. Chassis Bottom Cover....................................................................................................... 7-45
FIGURE 7-46. Fan Motor................................................................................................................................ 7-46
FIGURE 7-47. Heat Sink and Fan............................................................................................................... 7-47
FIGURE 7-48. Bed Disassembly.................................................................................................................. 7-48
FIGURE 7-49. Elevating Base with Three-shroud Assembly......................................................... 7-49
FIGURE 7-50. Replacing the Tilt Brake Pad.......................................................................................... 7-52
FIGURE 7-51. Humidifier Parts................................................................................................................... 7-54