GE Giraffe OmniBed Carestation CS1 - Page 15

Service Manual LOF-3
FIGURE 7-52. Probe Panel.............................................................................................................................7-56
FIGURE 7-53. Electronics Enclosure.........................................................................................................7-57
FIGURE 7-54. Installing Sensors.................................................................................................................7-60
FIGURE 7-55. Sensor Housing.....................................................................................................................7-61
FIGURE 7-56. Valve Housing........................................................................................................................7-63
FIGURE 7-57. End Cap Safety Valve.........................................................................................................7-64
FIGURE 7-58. Rear Cover...............................................................................................................................7-65
FIGURE 7-59. Alarm Lens ..............................................................................................................................7-66
FIGURE 7-60. Alarm Board ...........................................................................................................................7-66
FIGURE 7-61. Alarm Board Screws...........................................................................................................7-67
FIGURE 7-62. Tab..............................................................................................................................................7-67
FIGURE 7-63. Light Pipe .................................................................................................................................7-67
FIGURE 7-64. Remove the Bezel ................................................................................................................7-68
FIGURE 7-65. Temporary Support.............................................................................................................7-68
FIGURE 7-66. Remove Thread Forming Screws..................................................................................7-69
FIGURE 7-67. Set Down Display.................................................................................................................7-69
FIGURE 7-68. Harness Connectors...........................................................................................................7-70
FIGURE 7-69. Ferrite Position ......................................................................................................................7-70
FIGURE 7-70. Disconnect Power Harness.............................................................................................7-71
FIGURE 7-71. Disconnect Alarm PCA Harness....................................................................................7-71
FIGURE 7-72. Remove EMI Shield..............................................................................................................7-72
FIGURE 7-73. Remove SBC ...........................................................................................................................7-72
FIGURE 7-74. Do Not Use Screw................................................................................................................7-73
FIGURE 7-75. Screw Location......................................................................................................................7-73
FIGURE 8-1. Probe Panel Assembly.............................................................................................................8-2
FIGURE 8-2. Display Module Disassembly................................................................................................8-4
FIGURE 8-3. Electrical Enclosure...................................................................................................................8-7
FIGURE 8-4. Electrical Enclosure Ground Stackup ...............................................................................8-8
FIGURE 8-5. Electrical Enclosure Ground Stackup (cont’d)...............................................................8-9
FIGURE 8-6. Humidifier Transformer and RS-232.............................................................................8-12
FIGURE 8-7. Bed ................................................................................................................................................8-14
FIGURE 8-8. Side Panel (East/West)..........................................................................................................8-16
FIGURE 8-9. Rear (North) and Front (South) Wall ...............................................................................8-18
FIGURE 8-10. Radiant Heater......................................................................................................................8-20
FIGURE 8-11. Canopy......................................................................................................................................8-22
FIGURE 8-12. Enhanced Canopy Seal Parts.........................................................................................8-24
FIGURE 8-13. Heater Doors..........................................................................................................................8-26
FIGURE 8-14. Upper Chassis........................................................................................................................8-27
FIGURE 8-15. Lower Chassis........................................................................................................................8-30
FIGURE 8-16. Humidifier Assembly ..........................................................................................................8-32