Section 4 — Measurement Types and their Uses
92
11. Press to access the additional setup options:
a. Press Number of Averages to change the default number
of averages taken.
b. Press Manage Warnings > Enable or disable the warnings
as required.
c. Press Auto-Increment Upon Save to toggle between the
available options:
• Hammer Point — Hammer point name is incremented each
time you save.
• No Increase — Hammer point is not incremented.
• Sensor Point — Measure by impacting the same location
and moving the sensor (sensor point name is incremented).
d. Press Point Name Increment to change the default
interval at which points will automatically increment.
e. Press Sensor Setup to set up your channels and sensors
as required.
12. Press to exit when you have finished selecting the required
parameters.
Selecting the required parameter settings
To Next Page
Loading...
