Section 9 — Working with Routes
179
Complete Setup
Once you have selected your mode, you can complete the setup. To do
this:
1. Tell your instrument which channel to use for any other axes/points
(e.g. axial):
a. Press to select CH1.
b. Press to select CH2 — The text All Others will display.
2. Press to cancel multi-channel recording — The text (none) will
display in the left column. This indicates that no channels are
designated to a specific axis.
3. Press to redisplay your route.
4. Start recording as normal.
NOTE: A summary of the multichannel configuration displays on
the Route screen. For example, Points: Dual Chan 1, 2 indicates
dual channel acquisition in Points mode.
Triaxial Measurements
If you have a four-channel instrument, you can save time by using a
triax sensor to take three measurements at once. Configuring a triaxial
on-route recording on your instrument involves:
• Creating three locations at a single point in Ascent (e.g.
Horizontal, Vertical, Axial).
• Setting each of these locations to correspond with one of the
three available triax sensor axes (X, Y, or Z, matching the
orientation of the sensor when mounted).
To Next Page
Loading...
