Section 11 — Balancing Rotors
218
Set up Balancing Job
The Balance Setup menu gives you a large degree of flexibility in how
you set up balancing jobs. Many of the setup items are optional and you
can select items in any order you wish.
EG: You can select a machine to save the balancing report to at the
beginning or end of the process, or perform balancing without
saving the report.
To set up a balancing job:
1. Press Balance on the main menu.
2. Press New Job — This clears any existing setup data from
previous balancing jobs.
3. Press Setup > Use the options in the Balance Setup menu to
apply your preferred balancing settings.
Setting up a balancing job
The rest of this section describes the Balance Setup menu options.
Balancing Walkthrough explains how to use these options when
performing a balancing job.
To Next Page
Loading...
