Section 4 — Measurement Types and their Uses
107
Set up Sensors and Channels
To set up sensors and channels:
1. Select your measurement type and parameters as usual.
2. Press > Press Sensor Setup.
3. Assign and enable a sensor for each channel you are measuring.
4. Press Change Sensor opposite your chosen measuring channel.
NOTE: If this is new sensor that has NOT yet been defined in the
instrument, you will need to create a sensor definition before you
can assign it to a channel. See Defining and Editing Sensors.
5. Use the arrow keys to select a sensor > Press to assign it to
your channel.
6. To enable the channel for measuring, press a key on the left beside
your chosen channel — Enabled will display beside the channel to
indicate you can now use it to take measurements.
7. Repeat this process to enable additional channels.
8. Press twice to start measuring.
9. Save your measurements.
Setting up sensors and channels
To Next Page
Loading...
