Section 4 — Measurement Types and their Uses
63
Choosing to save only spectrum data when doing a
coast-down/run-up recording
Take Coast-down/run-up Measurement
To take a coast-down/run-up measurement:
1. Press or Measure.
2. Use the arrow keys on the left to highlight Coast-down/Run-up >
Press .
3. Use the arrow keys on the left to select a parameter set > Press
to create a new set.
4. Set the parameters as required.
5. Press > Select the machine location to save measurements to.
6. Press again to start measuring.
7. After the first spectrum has been recorded, switch off the machine,
or begin ramping its speed up or down.
8. Once the machine has stopped rotating, or its speed has been fully
adjusted, press to stop measuring and return to the Coast-
down/Run-up menu.
NOTE: The measurement location will contain several
measurements. You can transfer these to Ascent and display them
as a waterfall chart. If you used the tachometer as well, you can
also display your measurements as a bode plot.
To Next Page
Loading...
