Section 11 — Balancing Rotors
225
Reference Mark
Reference Mark is an optional item you can use in conjunction with CH
Position. Your instrument uses this information to calculate where on the
rotor you should place your trial weights after taking an initial reading.
You need to enter the Reference Mark Location and CH Position. This
enables your instrument to calculate the trial weight angle.
To enter your reference mark details:
1. Press Machine Information on the Balance Setup menu.
2. Press Reference Mark > Enter the angle from the tachometer
reflective tape to your reference mark > Press .
3. Enter zero if these marks are aligned with each other.
NOTE: Once you take the initial reading, your instrument will
display the suggested trial weight angle in the top right of the
screen.
To Next Page
Loading...
