GE SCOUT140-Ex - Take Off-Route Recording; Edit or Delete Route

Section 9 — Working with Routes
192
Take Off-Route Recording
When collecting data, you may decide to take additional measurements
that are NOT part of the route sequence. This might be necessary if a
machine's vibration pattern looks different to what you expected when
you took the measurement.
To take an off-route recording:
1. Press and hold to temporarily step out of the route and return
to the main menu — You can set up a new measurement from here.
2. Take and review the measurement as usual,
3. Save the measurement to the machine location (if required).
NOTE: When next you transfer data to your computer, any
additional recordings you have saved will be sent, along with the
collected route.
4. Press Route on the main menu to return to the route.
5. Use the arrow keys to select your route.
6. Press — A message will display ask if you wish to continue.
7. Press to continue from where you stopped measuring.
Edit or Delete Route
You can use Ascent to create, edit, and delete routes. You CANNOT edit
or delete routes directly on your instrument.
To remove a route:
1. Delete the route from the folder tree in Ascent.
2. Send the folder that used to contain the route to your instrument —
Because the folder no longer contains the original route, this route
will NOT display on your instrument.
NOTE: Deleting a route does NOT delete the machines and
parameter sets that comprise it. These will remain stored in the
instrument.
To edit a route, make your changes in the Ascent folder tree > Resend
the folder to your instrument.