GE SCOUT140-Ex - Setting Ethernet Network Address

Section 14 — Troubleshooting
265
Set Ethernet Network Address
To set the Ethernet network address:
1. Press Options on the main menu.
2. Press Comms.
3. Press Ethernet — A message will ask whether you wish to use
a DHCP server to assign an IP address to the instrument.
4. Use EITHER of these methods according to your requirements:
• Press to use DHCP > Press + to reset and apply
your changes.
• Press > Enter your new network IP values manually > Press
+ to reset the instrument hardware and apply your
changes.
NOTE: Dynamic Host Configuration Protocol (DHCP) is a network
protocol that automatically configures TCP/IP networked devices.
Reset Network Values to Factory Default
To reset the network values to the factory default:
1. Press Options on the main menu.
2. Press Comms.
3. Press Factory Default > Hold and press to reset
your instrument.
NOTE: The factory default values are Ethernet IP: DHCP (Auto).