Section 4 — Measurement Types and their Uses
62
Deactivate Saving Waveform Data for Coast-
down/Run-up Measurement
When you take a Coast-down/Run-up recording, the waveform data is
saved along with the spectrum data. However, this means the pace at
which you can take these recordings is slower. If you do not need to
collect the waveform data, we recommend you specify this when setting
up the recording. Doing so will enable you to take recordings much more
rapidly during the machine coast-down/run-up.
To deactivate this option and ensure only spectrum data is saved:
1. Press or Measure.
2. Locate and select the Coast-down/Run-up measurement type >
Press .
3. Press Spectrum Waveform.
4. Press Spec Wfm repeatedly to toggle between EITHER of these
options:
• Spec + Wfm — Spectrum and Waveform data will be saved
when you take a coast-down/run-up measurement.
• Spectrum — Only Spectrum data will be saved when you take a
coast-down/run-up measurement.
5. Press to confirm your selection.
To Next Page
Loading...
