Section 11 — Balancing Rotors
227
Tach Trigger
The Tach Trigger enables you to specify whether you are using a
standard tachometer or a Keyphasor®.
Weight Lin Dist
You can use Weight Lin Dist to specify the measurement units for linear
speed distance, balance weights, and rotor weight. To change the units
displayed:
1. Press Weight Lin Dist.
2. Press to cycle through the linear speed options or to
open the Weight Units menu where you can set balance and rotor
weight units.
3. Press to navigate back to the Balance Setup menu when you
have set your units.
Store Units
Store units enable you to specify your preferred measurement units and
overall scaling for balancing jobs.
Combine and Split Trim Weights
As you continue to fine-tune a balance job, you may end up with several
trim weights fixed at various angles on the balancing planes. You can
combine all trim weights for an individual plane into one weight/angle
solution, or split a larger trim weight into several smaller weight/angle
solutions using the Adjust Weights and Split Weight calculators.
To Next Page
Loading...
