Section 9 — Working with Routes
187
Save Route Recording
There are four ways to save your route recordings:
• Record & Review — The instrument will pause after taking a
measurement and continue to display the chart until you start
the next recording. You can use this mode if you want to
analyze each machine's condition as you collect the route.
• Auto Save — This method saves each recording. It then
redisplays the Route menu so you can select the next recording.
If required, you can review individual recordings as soon as you
have taken them, or at any time during route collection.
MORE: See Select Recording to Review.
• Free Run, Manual Save — The instrument takes a measurement
that updates continuously. This enables you to watch the signal
as it displays on your screen. You can save the measurement or
stop measuring without saving. This method is ideal if you want
to briefly check each machine's condition and only save
individual recordings when a machine requires further
investigation.
MORE: See Save Measurement.
• Auto+Delay — This method is the same as Auto Save. However,
it instructs the instrument to pause briefly on the measurement
screen after each route recording before returning to the Route
menu. This pause enables you to view the measurement briefly
before continuing with the route.
To Next Page
Loading...
