GE Vivid i

Measurement and Analysis
136 Vivid i User’s Manual
2378958-100 Rev. 02
Configuration of the Measurement result table
If AV CO calculation is not displayed in the Measurement result
table, follow the following procedure:
1. Press
CONFIG and select the category Measure.
The Measurement menu sheet is displayed.
2. The AV CO calculation is based on Doppler AV Trace
measurement in the folder Aortic, check Doppler in the
Measurement menu sheet and select the folder Aortic.
3. In the folder Aortic, select AV Trace measurement.
A list of all available calculations for the selected
measurement is displayed in the Measurement menu
sheet.
4. Check the box in front of AV CO.
The AV CO calculation will be displayed in the
Measurement result table.