Measurement and Analysis
Vivid i User’s Manual 141
2378958-100 Rev. 02
No units are necessary since the formula is a ratio (see
also "About units" on page 143).
12. Press Check to make sure that the syntax for the formula
is correct.
User-defined measurements
Some user-defined formula may require measurements that do
not exist on the system. The following example based on a
generic distance measurement illustrates how to create
user-defined measurements.
Figure 6-13: The Measurement menu sheet
1. Press CONFIG and select the category Measure.
2. In the Measurement menu sheet, select the appropriate
scanning mode for the measurement to be created (e.g.
2D).
3. Select the appropriate folder in the Measurement menu
(e.g. Dimension).
4. Press Add Measurement in the Measurement menu
sheet.
The Add measure window is displayed.
1. Select the appropriate scanning mode.
2. Select the appropriate folder.
3. Press Add measurement.
To Purchase, Visit Avobus.com or call 1-800-674-3655
To Next Page
Loading...
