Archiving
188 Vivid i User’s Manual
2378958-100 Rev. 02
Dataflow selection
Select a dataflow from the Search/Create Patient window (see
"Creating a new Patient record or starting an examination from
an existing patient record" on page 42) or configure the system
with a default dataflow from the Configuration management
package as described below.
Default dataflow selection
1. Press
CONFIG and log on as administrator if required.
2. Select the Connectivity category and Dataflow subgroup.
The Dataflow sheet is displayed (see Figure 8-27).
3. Select the desired dataflow in the Name pull-down menu
and check the option Default.
4. Press
CONFIG to exit the Configuration management
package.
Figure 8-27: Default dataflow setting
1. Select Connectivity category
2. Select Dataflow subgroup
3. Select a dataflow
4. Default option for the selected dataflow
To Next Page
Loading...
