Presets and System setup
316 Vivid i User’s Manual
2378958-100 Rev. 02
7. To remove a device from the dataflow, select the device in
the Selected devices field and press the Left arrow button.
Adjusting the assigned devices
1. Select the device in the Selected devices field.
2. Press Properties.
The Properties window is displayed.
3. Adjust the device specific parameters as desired (see table
below). Not all the settings listed below apply to all devices.
General settings Definition
Name Free text: give a descriptive name for the device.
IP address Select from drop-down menu
Database Name Automatically selected according to the IP address
File destination Automatically selected according to the IP address
Removable Check the entry is the media is removable.
Image settings Definition
Allow raw data
: save data in both raw and DICOM format.
: save data in DICOM format only.
Max Framerate Select 25, 30 or Full from the pop-up menu. Full (original
acquisition) is default.
Compression Select compression type or no compression.
Quality Set picture quality from 1 to 100%. A low picture quality
level allows high data compression, while a high picture
quality restrains the compression.
Allow Multiframe
: allow cineloop storage.
Connection settings Definition
Retry Set maximum number of connection tentatives, time
interval between tentatives and time-out.
To Next Page
Loading...
