Gerber Sabre - Page 80

72 Sabre Owner’s Guide
stopping............................................... 53
Job home position
and job size ......................................... 54
control pad key................................... 15
defined................................................... 9
returning to......................................... 21
setting .............................................. 9, 54
L
Language, changing............................... 18
LED indicators.......................................... 6
Lubricating, Z axis ................................. 60
M
Machine, selecting.................................. 11
Main power switch .................................. 6
Maintenance............................................ 58
daily cleaning ..................................... 58
daily inspection .................................. 58
weekly ................................................. 60
Manual routing....................................... 55
Mat milling.............................................. 37
Material
hold down guidelines........................ 46
holding down ..................................... 43
Z init key ............................................. 15
Material surface reference......... 32, 35, 53
MATL Z INIT key .................................. 35
Measurement units ................................ 19
Menus
control keys......................................... 15
selection keys...................................... 14
using .................................................... 14
Message displays.................................... 15
Messages.................................................. 68
Metal, routing ......................................... 46
Mist Coolant Option ........................ 29, 72
Motor
changing.............................................. 56
selecting............................................... 12
N
Nominal material thickness............ 31, 52
O
Options .................................................... 72
Orientation point................................ 9, 51
Orienting the system........................ 12, 43
Override
X,Y feed rate ................................. 15, 49
Z feed rate ........................................... 49
P
Paneled jobs ............................................ 54
Park position........................................... 54
Pause key................................................. 14
Pausing a job........................................... 53
Pen tool.................................................... 28
Phone numbers......................................... 2
Position, displaying ............................... 50
Positioning rate, changing .................... 21
Power switch............................................. 6
Power up
after firmware revision...................... 11
normal ........................................... 11, 12
tests ...................................................... 13
Pre-job checklist...................................... 42
Pre-position............................................... 9
Pressure foot ....................................... 8, 30
changing pads .................................... 31
PVC sheets, routing ............................... 48
R
Reset key............................................ 13, 14
Restarting a job ....................................... 53
Return 0,0 key......................................... 15
Router
changing motors ................................ 56
selecting............................................... 11
spindle, selecting................................ 12
Routing
a job................................................ 41, 51
emergency stop .................................. 53
non-through cutting .......................... 10
pausing and restarting ...................... 53
pre-job checklist ................................. 42
preliminary steps ............................... 11
safety guidelines ................................ 41
stopping............................................... 53
through-cutting .................................. 10
RPM key .................................................. 15
S
Sabre
operational concepts............................ 8
options................................................. 72
Sacrificial material.................................. 45
holding down ..................................... 44
Safety guidelines .............................. 37, 41
Set Actual Thickness menu................... 52
Slow key .................................................. 15
Specifications .......................................... 74
Speeds