Gerber Sabre - Page 81

Index 73
and feeds, setting ............................... 48
setting spindle .................................... 15
standard spindle, changing .............. 48
Spindle motor
warming up ........................................ 43
Spindle, selecting.................................... 12
Start
delay, setting....................................... 23
key........................................................ 14
position................................................ 54
Status message........................................ 12
Stopping a job ......................................... 53
Support First ............................................. 2
Surface reference ............ 31, 32, 33, 35, 52
material.......................................... 32, 35
table...................................................... 31
System settings ....................................... 16
T
Table
0,0 position...................................... 9, 51
protection, setting .............................. 22
surfacing tool................................ 25, 38
Z init key ............................................. 15
Table surface reference.................... 31, 32
TBL Z INIT key....................................... 34
Telephone numbers ................................. 2
Temp Adjust Depth menu .............. 36, 37
Through-cutting ......................... 10, 31, 32
Tool
adjusting initialization depth ........... 36
Gerber Gold ........................................ 25
installing.............................................. 26
kit contents............................................ 5
lowering .............................................. 15
raising............................................ 15, 50
removing............................................. 27
table surfacing .................................... 38
Tool Changer
Automatic ........................................... 73
Tool needed message............................. 43
Troubleshooting ..................................... 62
T-Vac
holding material without.................. 44
option................................................... 73
using .................................................... 45
U
Units, English and metric...................... 19
V
Vacuum for chip removal ..................... 30
W
Warming up the spindle ....................... 43
Weekly maintenance.............................. 60
Wood, routing......................................... 46
Workpiece, holding down .................... 43
X
X axis defined ........................................... 9
X,Y
feed rate............................................... 15
move keys ........................................... 15
overriding feed rate........................... 49
Y
Y axis defined ........................................... 9
Z
Z
axis, defined.......................................... 9
axis, initializing ...................... 10, 34, 52
axis, move keys .................................. 15
feed rate, overriding.......................... 49
up ......................................................... 50
up key.................................................. 15
Z feed rate ............................................... 49