4.2.2 Acknowledgement of an error code
WARNING!
The goods in the machine are not clean and must
be washed again from the beginning with a new
program.
WARNING!
If the goods are still hot after a program is
completed, handle them with care to avoid burns.
Acknowledge the alarm by:
• Noting the error code.
• Press to cancel the acoustic signal. The machine remains
locked but the process has been stopped.
• Press again. The display now shows the password entry
menu.
• Correct the error or call service personnel.
• Enter password (558387) using the arrow keys. Select the
key and press . All liquid is drained from the machine
and the door is unlocked. The symbol is lit on the panel and
indicates that the most recently run process is complete but
not approved.
• Open the door and take out the goods or start the process
over again.
4 ALARM MANAGEMENT
TECHNICAL MANUAL GETINGE WD15 CLARO 53 (128)
<Doc_TEC><Doc_6001396902><Rev.I><Lang_en>
To Next Page
Loading...
Need help?
General
