7.10 Printer Martel MCP8810X (Option)
This is how to connect the printer to the machine:
1. Connect the printer with the accompanying printer cable to
the “Printer/Netcom” port on the back of the machine.
2. Normally this will not require changing any settings as they
are correctly set by the factory. But if it does not work, check
that they are set according to the illustrations below.
7 REPAIRS AND ADJUSTMENT
TECHNICAL MANUAL GETINGE WD15 CLARO 93 (128)
<Doc_TEC><Doc_6001396902><Rev.I><Lang_en>
To Next Page
Loading...
