Firmware Version 1.0.2.21 UCM6100 Series IP PBX User Manual Page 109 of 159
Now the Fax configuration is done. When there is an incoming Fax calling to the PSTN number for the
FXO port, it will send the Fax to the Fax machine.
SAMPLE CONFIGURATION FOR FAX-TO-EMAIL
The following instructions describes a sample configuration on how to use Fax-to-Email feature on the
UCM6100.
1. Connect PSTN line to the UCM6100 FXO port.
2. Go to UCM6100 web GUI->Internal Options->Fax/T.38 page. Create a new Fax extension.
Figure 53: Create Fax Extension
3. Go to UCM6100 web GUI->Basic/Call Routes->Analog Trunks page. Create a new analog trunk.
Please make sure "Fax Detection" is set to "Yes".
http://arttel.ru
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102
To Next Page
Loading...
