Firmware Version 1.0.2.21 UCM6100 Series IP PBX User Manual Page 130 of 159
SIP SETTINGS
The UCM6100 SIP global settings can be accessed via Web GUI->PBX->SIP Settings.
SIP SETTINGS/GENERAL
Table 48: SIP Settings/General
Realm For Digest
Authentication
Configure the host name or domain name for the UCM6100. Realms
MUST be globally unique according to RFC3261. The default setting is
Grandstream.
Bind UDP Port Configure the UDP port used for SIP. The default setting is 5060.
Bind IP Address
Configure the IP address to bind to.
The default setting is 0.0.0.0, which
means binding to all addresses.
Allow Guest Calls
If enabled, the UCM6100
allows unauthorized INVITE coming into the
PBX and the call can be made. The default setting is "No".
Warning:
Please be aware of the potential security risk when enabling "Allow
" as this will allow any user with the UCM6100 address to
dial into the UCM6100.
Overlap Dialing Select to enable overlap dialing support. The default setting is "No".
Allow Transfer
If set to "No", all transfers initiated by the endpoint in the UCM6100 will
be disabled (unless enabled in peers or users)
"Yes".
Enable DNS SRV Lookups on
Outbound Calls
Select to enables DNS SRV lookups on outbound calls
UCM6100. The default setting is "Yes".
MWI From
When sending MWI NOTIFY requests, this value will be used
"From:" header as the "name" field. If no "From U
"user" field of the URI in the "From:" header will be filled with this value.
SIP Domain Support
Domain
Configure the domain for the UCM6100
. Incoming INVITE and REFER
messages can be matched against a list of "allowed" domains, each of
which can direct the call to a specific context if desired. By default, all
domains are accepted and sent to the default context or the context
associated with the user/peer placing the call. Register to non-local
domains will be automatically denied if a domain list is configured. Up to
10 domains can be added.
http://arttel.ru
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102