Firmware Version 1.0.2.21 UCM6100 Series IP PBX User Manual Page 127 of 159
IAX SETTINGS
The UCM6100 IAX global settings can be accessed via Web GUI->PBX->IAX Settings.
IAX SETTINGS/GENERAL
Table 45: IAX Settings/General
Bind Port
Configure the port number that the IAX2 will be allowed to listen to. The
default setting is 4569.
Bind Address
Configure the address that the IAX2 will be forced to bind to. The default
setting is 0.0.0.0, which means all addresses.
IAX1 Compatibility Select to configure IAX1 compatibility. The default setting is "No".
No Checksums
If selected, UDP checksums will be disabled and no checksums will be
calculated/checked on systems sup
porting this features. The default
setting is "No".
Delay Reject
If enabled, the IAX2 will delay the rejection of calls to avoid DOS. The
default setting is "No".
ADSI Select to enable ADSI phone compatibility. The default setting is "No".
Music On Hold Interpret
Specif
y which Music On Hold class this channel would like to listen to
when being put on hold. This music class is only effective if this channel
has no music class configured and the bridged channel putting the call
on hold has no "Music On Hold Suggest" setting.
Music On Hold Suggest
S
pecify which Music On Hold class to suggest to the bridged channel
when putting the call on hold.
Bandwidth Configure the bandwidth for IAX settings. The default setting is "Low".
IAX SETTINGS/REGISTRATION
Table 46: IAX Settings/Registration
IAX Registration Options
Min Reg Expire
Configure the minimum period (in seconds) of registration. The default
setting is 60.
Max Reg Expire
Configure the maximum period (in seconds) of registration. The default
setting is 3600.
http://arttel.ru
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102
To Next Page
Loading...
Need help?
General
