Firmware Version 1.0.2.21 UCM6100 Series IP PBX User Manual Page 122 of 159
INTERNAL OPTIONS
This section describes internal options that haven't been mentioned in previous sections yet. The settings in
this section can be applied globally to the UCM6100, including general configurations, jitter buffer, RTP
settings, hardware config and STUN monitor. The options can be accessed via Web GUI->PBX->Internal
Options.
INTERNAL OPTIONS/GENERAL
Table 40: Internal Options/General
General Preferences
Global OutBound CID
Configure the global CallerID used for all outbound calls when no other
CallerID is defined with higher priority. If
no CallerID is defined for
extension or trunk, the global outbound CID will be used as CallerID.
Global OutBound CID Name
Configure the global CallerID Name
used for all outbound calls. If
configured, all outbound calls will have the CallerID Name set to this
name. If not, the extension's CallerID Name will be used.
Operator Extension
Specify the operator extension, which will be dialed when users presses
0 to exit voicemail application. The operator extension can also be used
in IVR option.
Ring Timeout
Configure the number of seconds to ring an ex
goes to the user's voicemail box. The default setting is 60.
Note:
This is the global value used for each extension if "Ring Timeout" field is
left empty on the extension configuration page.
Record Prompt
If enabled, users will
hear voice prompt before recording is started or
stopped. For example, before recording, the UCM6100 will play voice
prompt "The call will be recorded". The default setting is "No".
Extension Preferences
Enable Random Password
If enabled, random passwor
d will be generated when the extension is
created. The default setting is "Yes"
. It is recommended to enable it for
security purpose.
Disable Extension Range
If set to "Yes", users could disable the extension range
pre-configured/configured on the UCM6100. The default setting is "No".
http://arttel.ru
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102