Firmware Version 1.0.2.21 UCM6100 Series IP PBX User Manual Page 54 of 159
EXTENSIONS
CREATE NEW USER
To manually create new user, go to Web GUI->PBX->Basic/Call Routes->Extensions. Click on "Create
New User" and a new dialog window will show for users to fill in the extension information. The configuration
parameters are as follows.
Table 20: Extension Configuration Parameters
General
Extension The extension number associated with the user.
CallerID Name
Configure the CallerID Name associated with the user. Number, letter,
or space are allowed.
CallerID Number
Configure the CallerID Number
that would be applied for outbound calls
from this user.
Note:
The ability to manipulat
e your outbound Caller ID may be limited by your
VoIP provider.
Permission
Assign permission level to
the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls using this rule.
SIP/IAX Password
Configure the password for the user. A random secure password will be
tically generated. It is recommended to use this password for
security purpose.
Enable Voicemail Enable voicemail for the user. The default setting is "Yes".
Voicemail Password
Configure voicemail password (digits only)
for the user to access the
voicemail box. A random numeric password is automatically generated.
It is recommended to use the random generated password for security
purpose.
Email Address Fill in the Email address for the user.
Call Forward Unconditional
Configure the Call Forward Uncondi
tional target number. If not
configured, the Call Forward Unconditional feature is deactivated. The
http://arttel.ru
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102
To Next Page
Loading...
Need help?
General
