Grandstream Networks UCM6108 User Manual

Firmware Version 1.0.2.21 UCM6100 Series IP PBX User Manual Page 128 of 159
IAX Thread Count Configure the number of IAX helper threads. The default setting is 10.
IAX Max Thread Count
Configure the maximum number of IAX threads allowed. The default
setting is 100.
Auto Kill
If set to "yes", the connection will be terminated if
ACK for the NEW
message is not received within 2000ms
. Users could also specify
number (in milliseconds) in addition to "yes" and "no". The default setting
is "yes".
Authentication Debugging
If enabled, authentication traffic in debugging will not show. The default
setting is "No".
Codec Priority
Configure codec negotiation priority. The default setting is "Reqonly".
x Caller
Consider the callers preferred order ahead of the host's.
x Host
Consider the host's preferred order ahead of the caller's.
x Disabled
Disable the consideration of codec preference all together.
x Reqonly
This is almost the same as "Disabled"
, except when the requested
format is not available.
The call will only be accepted if the
requested format is available.
Type of Service Configure ToS bit for preferred IP routing.
IAX Trunk Options
Trunk Frequency
Configure the frequency of trunk frames (in milliseconds).
The default
setting is 20.
Trunk Time Stamps
If enabled, time stamps will be attached to trun
k frames. The default
setting is "No".
IAX SETTINGS/STATIC DEFENSE
Table 47: IAX Settings/Static Defense
Call Token Optional
Enter a single IP address or a range of IP addresses for which call token
validation is not required.
For example:
11.11.11.11
11.11.11.11/22.22.22.22.
http://arttel.ru
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102

Grandstream Networks UCM6108 Specifications

General

Brand	Grandstream Networks
Model	UCM6108
Category	PBX
Language	English