Firmware Version 1.0.2.21 UCM6100 Series IP PBX User Manual Page 116 of 159
Note:
x To configure LDAP sync, please go to UCM6100 web GUI->PBX->Basic/Call Routes->VoIP Trunk.
You will see "Sync LDAP Enable" option. Once enabled, please configure password information for
the remote peer UCM6100 to connect to the local UCM6100. Additional information such as port
number, LDAP outbound rule, LDAP Dialed Prefix will also be required. Both the local UCM6100 and
remote UCM6100 need enable LDAP sync option with the same password for successful connection
and synchronization.
x Currently LDAP sync feature only works between two UCM6100s.
x (Theoretically) Remote BLF monitoring will work when the remote PBX being monitored is
non-UCM6100 PBX. However, it might not work the other way around depending on whether the
non-UCM6100 PBX supports event list BLF or remote monitoring feature.
http://arttel.ru
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102
To Next Page
Loading...
Need help?
General
