Grandstream Networks UCM6108 User Manual

Firmware Version 1.0.2.21 UCM6100 Series IP PBX User Manual Page 119 of 159
x Configure the maximum interval (in milliseconds) between the
digits input to activate the feature code.
Call Park
x Default Extension: 700.
x During an active call,
initiate blind transfer and then enter this
code to park the call.
Parked Lots
x Default Extension: 701-720.
x These are the
extensions where the calls will be parked, i.e.,
parking lots that the parked calls can be retrieved.
Parking Timeout (s)
x Default setting: 300.
x This is the timeout allowed for a
call to be parked. After the
timeout, if the call is not picked up, the extension who parks
the call will be called back.
Feature Codes
Voicemail Access Code
x Default Code: *98.
x
Enter *98 and follow the voice prompt. Or dial *98 followed by
the extension and # to access the entered extension's
voicemail box.
My Voicemail
x Default Code: *97.
x Press *97 to access the voicemail box.
Agent Pause
x Default Code: *83.
x Pause the agent in all call queues.
Agent Unpause
x Default Code: *84.
x Unpause the agent in all call queues.
Paging Prefix
x Default Code: *81.
x To page an extension, enter the
code followed by the
extension number.
Intercom Prefix
x Default Code: *80.
x To intercom
an extension, enter the code followed by the
extension number.
Blacklist Add
x Default Code: *40.
x
To add a number to blacklist for inbound route, dial *40 and
follow the voice prompt to enter the number.
Blacklist Remove
x Default Code: *41.
x
To remove a number from current blacklist for inbound route,
dial *41 and follow the voice prompt to remove the number.
Call Pickup on Ringing
x Default Code: **.
x To pick up a call for any
extension xxxx, enter the code
followed by the extension number xxxx.
http://arttel.ru
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102

Grandstream Networks UCM6108 Specifications

General

Brand	Grandstream Networks
Model	UCM6108
Category	PBX
Language	English