Firmware Version 1.0.2.21 UCM6100 Series IP PBX User Manual Page 32 of 159
default interface in option "Default Interface". Users will need assign LAN 1
or LAN 2
as the default interface in option "Default Interface" and configure
"Gateway IP" for this interface.
Preferred DNS Server Enter the preferred DNS server address.
LAN (when Method is set to "Switch")
IP Method Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
Gateway IP Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
Subnet Mask
Enter the subnet mask address for static IP settings. Th
255.255.0.0.
IP Address Enter the IP address for static IP settings. The default setting is 192.168.0.160.
DNS Server 1
Enter the DNS server 1 address for static IP settings.
0.0.0.0.
DNS Server 2 Enter the DNS server 2 address for static IP settings.
User Name Enter the user name to connect via PPPoE.
Password Enter the password to connect via PPPoE.
Layer 2 QoS
802.1Q/VLAN Tag
Assign the VLAN tag of the layer 2 QoS packets for LAN port. The default value
is 0.
Layer 2 QoS 802.1p
Priority Value
Assign the priority value of the layer 2 QoS packets for LAN port. The default
value is 0.
LAN 1 / LAN 2 (when Method is set to "Dual")
Default Interface
If "Dual" is selected as "Method", users will need assign the default interface to
be LAN 1 or LAN 2. The default interface is LAN 2.
IP Method Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
Gateway IP Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
Subnet Mask
Enter the subnet mask address for static IP settings.
255.255.0.0.
IP Address Enter the IP address for static IP settings. The default setting is 192.168.0.160.
DNS Server 1
Enter the DNS server 1 address for static IP settings.
0.0.0.0.
DNS Server 2 Enter the DNS server 2 address for static IP settings.
User Name Enter the user name to connect via PPPoE.
Password Enter the password to connect via PPPoE.
Layer 2 QoS
802.1Q/VLAN Tag
Assign the VLAN tag of
the layer 2 QoS packets for LAN port. The default value
is 0.
Layer 2 QoS 802.1p
Priority Value
Assign the priority value of the layer 2 QoS packets for LAN port. The default
value is 0.
http://arttel.ru
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102