Firmware Version 1.0.2.21 UCM6100 Series IP PBX User Manual Page 76 of 159
to use this rule.
x National: Users with National or International level are
use this rule.
x International: The highest level required. Only users with
international level can use this rule.
The default setting is "International". Please be aware of the potential
security risks when using "Internal" level, which means all users can use
this outbound rule to dial out from the trunk.
Password
Configure the password for users to use this rule when making outbound
calls.
Send This Call Trough Trunk
Use Trunk Select the trunk for this outbound rule.
Strip
Allows the user to specify the number of digits that will be
the beginning of the dialed
string before the call is placed via the
selected trunk.
Example:
The users will dial 9 as the first digit of a long distance calls. However, 9
should not be sent out via analog lines and the PSTN line. In this case, 1
digit should be stripped before the call is placed.
Prepend
Specify the digits to be prepended before the call is placed via the trunk.
Those digits will be prepended after the dialing number is stripped.
Use Failover Trunk
Failover Trunk
Failover trunks can be used to make sure that a call goes through an
alternate route, when the primary trunk is busy or down. If "Use Failover
Trunk" is enabled and "Failover trunk" is defined, the calls that cannot be
placed via the regular trunk may have a secondary trunk to go through
Example:
The user's primary trunk is a VoIP trunk and the user would like to use
the PSTN when the VoIP trunk is not available. The PSTN trunk can be
configured as the failover trunk of the VoIP trunk.
Strip
Allows the user to specify the number of digits that will be
the beginning of the dialed
string before the call is placed via the
selected trunk.
Example:
The users will dial 9 as the first digit of a long distance calls. However, 9
http://arttel.ru
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102
To Next Page
Loading...
Need help?
General
