Grandstream Networks UCM6108 User Manual

Firmware Version 1.0.2.21 UCM6100 Series IP PBX User Manual Page 78 of 159
use this rule.
x International: The highest level required. Only users with
international level can use this rule.
This setting is used to compared with the outbound trunk's permission
level when the inbound call dials out via a trunk on the UCM6100.
Therefore, it's usually used only when the "Default Destination" is set to
"By DID".
Default Destination
Select the default destination for the inbound call.
x By DID
When "By DID" is used, the UCM6100 will look for the destination
based on the number dialed, which could be local extensions,
conference, call queue, ring group, pagin
g/intercom group, IVR,
voicemail groups and Fax extension as configured in "DID
destination" under "DID Features" dialog. If the dialed number
matches the DID pattern, the call will be allowed to go through.
x Extension
x Voicemail
x Conference Room
x Queue
x Ringgroup
x Page
x Vmgroup
x Fax
x DISA
x IVR
Time Condition
Start Time Select the start time "hour:minute" for the trunk to use the inbound rule.
End Time Select the end time "hour:minute" for the trunk to use the inbound rule.
Date
Select "By Week" or "By Day" and s
pecify the date for the trunk to use
the inbound rule.
Week Select the day in the week to use the inbound rule.
Destination
Select the default destination for the inbound call.
x By DID
When "By DID" is used, the UCM6100 will look for the destination
based
on the number dialed, which could be local extensions,
conference, call queue, ring group, paging/intercom group, IVR,
voicemail groups and Fax extension as configured in "DID
destination" under "DID Features" dialog. If the dialed number
http://arttel.ru
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102

Grandstream Networks UCM6108 Specifications

General

Brand	Grandstream Networks
Model	UCM6108
Category	PBX
Language	English