C-3
2.11 Running Cutting Tests ..............................................2-56
Cutting test ................................................................2-56
To make 1 cut with set value .................................................2-56
To make 3 cuts with set value and ±1 of set value .................................2-57
Conrm the results of the cutting test ...........................................2-59
Adjustment of Offset .......................................................2-59
Adjustment for Half Cutting ..................................................2-59
Adjustment for cutting out ...................................................2-59
Adjustment when using plotting pen ...........................................2-59
Adjust the blade length (Automatic Height Adjust) .................................2-60
2.12 About Simple mode ................................................2-63
Changing Mode ...........................................................2-64
2.12.1 Setting Page Length (Simple mode) ..............................................2-65
2.12.2 Origin Point Settings When conguring HP-GL (Simple mode). . . . . . . . . . . . . . . . . . . . . . . . . .2-67
2.12.3 GP-GL Step Size (Simple mode) .................................................2-68
2.12.4 Display Language Settings (Language) (Simple mode) ...............................2-69
2.12.5 Display Length Unit Settings (Length Unit) (Simple mode) .............................2-70
2.13 Displaying Cutting Area ............................................2 -71
Chapter 3: Basic Operations
3.1 Raise or Lower the Tool .............................................. 3-2
3.2 Move the Tool Carriage and Media .....................................3-3
Move in steps manually .......................................................3-3
Continuously move manually ...................................................3-3
Setting step movement distance ................................................3-4
Move away the tool carriage ...................................................3-5
Change the cutting condition (Condition No.) ......................................3-6
Reset (Revert to the initial state when the power was turned on.) .......................3-6
3.3 Setting the Origin Point .............................................. 3 -7
When coordinate axes rotation are set ...........................................3-8
When coordinate axes are rotated after origin point is set ............................3-8
Setting origin point when HP-GL is set ...........................................3-9
3.4 Setting the Cutting Direction ........................................3 -10
3.5 Stop Cutting ......................................................3 -12
Pause and resume cutting ....................................................3 -12
Stop cutting ...............................................................3 -13
Chapter 4: Convenient Functions
4.1 Settings for Cutting .................................................4-2
Setting cutting area ..........................................................4-2
Setting cutting width (EXPAND) ................................................4-4
Setting length of the page .....................................................4-5
Setting mirror ...............................................................4 -7
Set the enlarge/shrink scale (Scale) .............................................4-8
4.2 Copy (Duplicate Cutting) ............................................4 -10
When media change mode is OFF ............................................4 -10
When media change mode is ON .............................................4 -13
4.3 Panel Cutting .....................................................4 -15
To Next Page
Loading...
