4-14
Supplement
"CANNOT COPY CUT AREA TOO SMALL!" is
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or set
the media that is big enough to copy.
7
Conrm the setting and press the [ESC] key (PREVIOUS).
NUMBER OF COPIES will be selected and it will return to COPY MODE
screen.
8
Conrm the setting and press the [ENTER] key (SET).
The plotter starts a copy immediately.
Supplement
Cutting data is stored even if the media is
exchanged. It can be copied as many times
until the buffer memory is cleared. It can be
copied again after exchanging the media by
pressing [COPY] key.
9
Replace the media. (When the number of copies is "2" or
more)
"COPY MODY CHANGE MEDIA!" will be displayed on the screen.
10
The plotter starts a copy immediately after replacing the
media.
This operation's specied number of copies will be repeated.
To suspend, press the [ESC] key (QUIT COPY).
To Next Page
Loading...
