GRAPHTEC CE7000 Series - Page 149

5-15
Supplement
It will return to ARMS SETTING screen (2/3)
without changing the settings when you press
the [ESC] key (CANCEL).
6
Press the [4] key (TEST ARMS SENSOR).
TEST ARMS SENSOR screen is displayed.
Supplement
It will return to TEST ARMS SENSOR screen
without changing the settings when you press
the [ESC] key (CANCEL).
7
Press either the [1] key (TYPE 1) or the [2] key (TYPE 2)
depending on the type of the registration mark to be used.
Following message is displayed.
8
Move the tool to the position to start scanning of the
registration mark by pressing the POSITION ( ) key.
Registration mark scan area
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Feed direction of media
Move the tool inside this
area
Move the tool inside this
area
Supplement
Following error is displayed when the
registration mark was not scanned properly.
Press the [1] key (RETRY) to scan again, or the
[ESC] key (CANCEL) to exit.
9
Conrm the position of the tool and press the [ENTER] key.
The plotter will automatically detect the registration mark and cut the
peak of each registration mark.
10
Conrm the cutting result.
See "Adjusting for the Registration Mark Scan Position" and adjust if the
cutting position is shifted.