GRAPHTEC CE7000 Series - Page 167

6-7
16
Conrm the setting and press the [ENTER] key (SET).
The adjustments based on the registration mark scanning will be
completed, and it will return to default screen.
Supplement
•
It will return to default screen without changing
the settings when you press the [ESC] key
(CANCEL).
•
DISTANCE input screen for point 3 is displayed if
it is set to 3POINTS or more, so repeat steps 14 to
16 to set.
Supplement
Please refer to the following for adjustments when matching the manual position.
•
2 point matching, ["Point 1" settings] ["Point 2" settings] ["Origin point of the axis adjustment" settings] [Finish]
•
3 point matching, ["Point 1" settings] ["Point 2" settings] ["Point 3" settings] ["Distance between Point 1-2" settings] ["Distance
between Point 1-3" settings] ["Origin point of the axis adjustment" settings] [Finish]
•
4 point matching, ["Point 1" settings] ["Point 2" settings] ["Point 3" settings] ["Point 4" settings] ["Distance between point 1-2" settings]
["Distance between point 1-3" settings] [Finish]