GRAPHTEC CE7000 Series - Page 192

7-24
Supplement
You can set the range between -3.0 mm and
+3.0 mm.
9
Press the POSITION ( ) keys and increase or decrease the
setting value.
10
Conrm the setting and press the [ESC] key (PREVIOUS).
Tool Interval Adjustment screen is displayed.
11
Press the [4] key (Y=+0.0mm).
Tool 1-3 Interval Adjustment (Y) screen is displayed.
Supplement
You can set the range between -3.0 mm and
+3.0 mm.
12
Press the POSITION ( ) keys and increase or decrease the
setting value.
13
Conrm the setting and press the [ESC] key (PREVIOUS).
TOOL OFFSET ADJ. screen is displayed.
14
Repeat steps 4 to 13 until the misalignment between the two
tools is corrected.
Supplement
It will return to TOOLS SETTING screen (1/4)
without changing the settings when you press
the [ESC] key (CANCEL).
15
Conrm the interval and press the [ENTER] key (SET).
Setting will be conrmed and it will return to TOOL SETTING (1/4)
screen.
16
Press the [PAUSE/MENU] key.
It will return to default screen.