13-17
When using Cutting Master 4
1
In Adobe Illustrator, select "Cutting Master 4" -
"Registration Marks (CM4)" from the File menu.
In Corel DRAW, select "Launch" - "Registration Marks
(CM4)" from the tool bar.
* If selecting from the application launcher in CorelDRAW
version X7 or earlierand, the Registration Marks screen
will be displayed.
2
Check the "Use Barcode".
Select the "Standard" from the "Barcode Type".
3
Check the "Keep Registration Marks".
Press the “OK”.
* The fololowing screen is the screen when starting from
Adobe Illustrator.
4
A bar code is created on the design screen.
G0100SYAA
G0100SYAC
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Bar code Bar code
To Next Page
Loading...
