GRAPHTEC CE7000 Series - Page 274

13-20
Step 5: Cut the printed media.
Using the cutting data saved in the USB memory in Step 4, cut the media prepared in Step 3 with the cutting
plotter.
Operation
Supplement
For loading media, see "Loading Media (Paper
or Marking Film)".
5-
1 Load the printed media on the cutting plotter.
G0100SYAA
G0100SYAC
Feed direction of media Feed direction of media
MARK TYPE 1 MARK TYPE 2
5-
2 Insert the USB memory that saved the le into the USB
memory slot of the cutting plotter.
5-
3 Set the menu of cutting plotter.
Supplement
Perform the settings in Normal mode.
5-
4 Press the [PAUSE / MENU] key.
MENU screen is displayed.
Supplement
Conrm that the "Destination" is "USB memory".
5-
5 Press the ( ) key (LINK).
DATA LINK screen (1/2) is displayed.