15-23
5
Press the [3] key (DATA DUMP).
DATA DUMP start screen is displayed.
6
Conrm that the pen tool is set.
CAUTION
Do not place your hand around the moving
areas. The tool carriage will start moving, so
there is a chance of injury.
7
Conrm that operation area of tool and media is safe.
Supplement
It will return to TEST screen without printing by
pressing the [ESC] key (CANCEL DATA DUMP).
8
Press the [1] key (DONE).
9
Send the cutting data.
The received cutting data (command) is output.
Supplement
It will keep on printing until the power is turned
off once the printing is started by pressing the [1]
key (DONE).
10
Turn the power off to stop the printing.
To Next Page
Loading...
